Search found 3 matches

Re: Rode cable... noise with a dynamic mic

As for chassis ground to pin 1, I can confirm both cables are wired that way. Pedantically, it's not about chassis ground and pin 1, but the XLR shell and pin 1. And you should measure this with both ends of the cable disconnected. Inside the device, it's not uncommon for audio ground and chassis g...
by jacobvosmaerThu Oct 21, 2021 3:22 pm
Forum: Recording: Gear & Techniques Topic: Rode cable... noise with a dynamic mic Replies: 14 Views: 385

Re: No Sound From Kurzweil K2500RS After SCSI2SD Install

Is the volume turned up? Have you tried different outputs, including the headphone out? Are all the cables on the inside seated correctly? An unplugged board-to-board connector is a possibility after one has had the cover off and worked on the inside. The K2000R has a function where if you hold Canc...
by jacobvosmaerWed Feb 10, 2021 9:59 pm
Forum: Keyboards & Synthesis Topic: No Sound From Kurzweil K2500RS After SCSI2SD Install Replies: 8 Views: 256

Re: Dynacord mixers?

Arpangel wrote: Thanks for looking that up, shame, a bit too big for me.

For what it's worth, the Cadac Live 1 apparently comes in three sizes (8, 16 or 24 mono channels) and that picture shows the middle size. The smallest version is rack-mountable.
by jacobvosmaerFri Jun 26, 2020 6:59 pm
Forum: Recording: Gear & Techniques Topic: Dynacord mixers? Replies: 11 Views: 282